Sony Magnescale LH51 Instruction Manual page 68

Linear compensation amount
60
Select any compensation amount per meter (or per inch) referring to the following table.
When initializing the compensation amount, its least significant three digits will be displayed.
Select an appropriate value from the table.
No compensation
Plus (+) setting
Minus (–) setting
• When the error characteristics of the machine are known, select the most suitable
compensation amount from the table, and perform setting of addition or subtraction referring to
"5-1-3. Setting the linear compensation."
• When the error characteristics of the machine are unknown, measure the error to be
compensated according to the method described in 6-2. and select an appropriate
compensation amount from the table. Set the selected amount according to "5-1-3. Setting the
linear compensation."
Compecsation amount
Per meter Per inch (inches)
0 0
0.001 mm 0.000001"
0.002 mm 0.000002"
0.003 mm 0.000003"
0.004 mm 0.000004"
0.005 mm 0.000005"
0.006 mm 0.000006"
0.007 mm 0.000007"
0.008 mm 0.000008"
0.009 mm 0.000009"
0.010 mm 0.0000010"
0.015 mm 0.0000015"
0.020 mm 0.0000020"
(0.005 mm step) (0.000005" step)
0.600 mm 0.000600"
–0.001 mm –0.000001"
–0.002 mm –0.000002"
–0.003 mm –0.000003"
–0.004 mm –0.000004"
–0.005 mm –0.000005"
–0.006 mm –0.000006"
–0.007 mm –0.000007"
–0.008 mm –0.000008"
–0.009 mm –0.000009"
–0.0010 mm –0.0000010"
–0.0015 mm –0.0000015"
–0.0020 mm –0.0000020"
(0.005 mm step) (0.000005" step)
–0.600 mm –0.000600"
Initial setting display
LC 000
LC 001
LC 002
LC 003
LC 004
LC 005
LC 006
LC 007
LC 008
LC 009
LC 010
LC 015
LC 020
LC (005 step)
LC 600
LC –001
LC –002
LC –003
LC –004
LC –005
LC –006
LC –007
LC –008
LC –009
LC –010
LC –015
LC –020
LC (005 step)
LC –600