Table of Contents
Advertisement
4.2.3 Accessing the Parameters
4-4
Parameters are accessed through the menus. The menu paths to get to parameters
are provided:
•
In appendix A of this manual.
•
As part of the parameter descriptions in the software manual.
Some parameters and parameter options are only available if the appropriate option is
installed. For example, the
only displayed if an I/O Expansion kit is installed. The cursor changes to a lock (
parameters or options that are not available.
If you exit program mode from a parameter entry screen, you are returned to that
screen when you come back to program mode.
Basics of Accessing a Parameter
Step 1. Select the menu that contains the parameter.
Step 2. Press
and 2 for each menu until the parameter list you want is displayed.
Step 3. Move the cursor to the parameter you want to change. Press
The parameter value entry screen is displayed. It allows you to look at or change
parameter values.
Example of Accessing the
Step 1. At the Main Menu, press
shown in figure 4.5.
Step 2. Press
1 option for
ANALOG IN
. The next menu or parameter list is displayed. Repeat steps 1
1
METER OUT
SELECT
to move the cursor ( ) to Input/Output as
Figure 4.5 – Selecting the Input/Output Menu
. The Input/Output menu is displayed, as shown in figure 4.6.
Figure 4.6 – Input/Output Menu
TRIM REFERENCE SELECT
Parameter
FlexPak 3000 DC Drive OIM User's Guide
(P.108) is
for
)
.
Advertisement
Table of Contents
