About The Control Source; Table 6.1 - Effect Of Control Source And Reference Settings On The Auto/Manual - Rockwell Automation FlexPak 3000 OIM User Manual

6.2.1 About the Control Source

Table 6.1 – Effect of Control Source and Reference Settings on the AUTO/MANUAL Indicator and OIM Displays
Control Source
Automatic reference from the
KEYPAD
terminal strip as set by
REFERENCE SELECT
OIM
Automatic reference from the
TERMBLK
(Regulator type is terminal strip as set by
speed/voltage)
REFERENCE SELECT
Manual reference from the
terminal strip as set by
MANUAL REF SELECT
Automatic reference from the
SERIAL
terminal strip as set by
REFERENCE SELECT
Serial device (
Network
NETWORK
Automatic reference from the
TERMBLK
(Regulator type is terminal strip as set by
current/torque)
REFERENCE SELECT
Using the OIM to Monitor and Control the Drive
The possible control sources are:
•
: Control is through the keypad.
KEYPAD
•
: Control is through Regulator board terminals 16 through 20. See the
TERMBLK
hardware manual for terminal descriptions and wiring instructions.
•
: Control is through a personal computer running the CS3000 software.
SERIAL
•
: Control is through a network such as the AutoMax Network
NETWORK
Communication kit or DeviceNet Interface kit.
If the drive is configured as a current (torque) regulator (jumper J15 is set to
), the control source can only be set to
CURRENT
software manual for information.
When the control source is a device other than the
only through the selected control source. However, the
settings made by that control source. For example, if the drive is commanded to run
from another control source, the Running indicator will be on.
Table 6.1 shows the possible control source and reference source settings. It also
shows the display for the key indicator under
Reference Set Through
AUTO
(P.103)
AUTO
(P.103)
(P.106)
AUTO
(P.103)
)
PC
AUTO
(P.103)
TERMBLK
OIM
Key
Reference Display
Indicator (Monitor Mode)
AUTO TERMBLK REF
MANUAL KEYPAD REF
AUTO TERMBLK REF
MANUAL
AUTO
MANUAL SERIAL REF
(Manual
AUTO NETWORK REF
not available)
(Manual
AUTO TORQUE REF
not available)
or . See the
NETWORK
, you can change the settings
keypad/display reflects the
OIM
.
Units
,
RPM
percentage, or
user-scaled
units
From network
MOTOR LOAD
units
6-3