Table of Contents
Advertisement
4.4 Saving and Restoring Parameter Values
4.4.1 Using Memory Operations to Save and Restore Parameter Values
Basics of Configuring the Drive Using the OIM
Through the
, you can save parameter values, restore parameter values from a
OIM
previous save, or restore default parameter values.
Memory Save
You must use Memory Save to save changes to parameter values and the language
setting through a power cycle. Any values that are not saved revert to the previous
value on power cycle.
Important: Memory Save does not save the
the
PASSWORD
Memory Restore
Restores the parameter values and monitor mode configuration from the last Memory
Save. Use Memory Restore if changes were made to the
keep. If a Memory Save has never been performed, the factory defaults are restored.
Restore Defaults
Restores parameter values and monitor mode to the configuration set by the factory.
Important: After performing Restore Defaults, you should configure the parameters in
the Quick Start menu and perform the self-tuning procedure, described in
chapter 5.
To save, restore, or restore defaults:
Step 1. Press
Main Menu" is displayed at the top of the screen.
Step 2. Select Operator Interface. Press
Step 3. Select Memory Operations. Press
is displayed.
, you must use the CS3000 software.
until the
indicator reads
Figure 4.11 – Memory Operations Screen
parameter setting. To save
PASSWORD
that you do not want to
OIM
and "FlexPak 3000
PROGRAM
.
. The menu shown in figure 4.11
4-9
Advertisement
Table of Contents
