Sync Configuration; Connecting To Sync - Automatic Detect; Connecting To Sync - Manual; Communication Interface - Omega SP-014 User Manual

Link process monitoring smart probe

Hide thumbs Also See for SP-014:

Table of Contents

SYNC Configuration

Omega Link Smart Probe products are easily configured through Omega's free SYNC configuration software. Ensure

SYNC is running on a Windows OS computer before continuing. Connect the SP-014 to the computer using your

Omega Link Smart Interface to begin.

Note:

SYNC is available to download for free on the OMEGA website.

5.1

Once the SP-014 and Omega Link Smart Interface are connected to the computer, SYNC will automatically detect the

probe and begin displaying readings.

Note:

If living readings from the SP-014 are displayed on SYNC, skip ahead to section Error! Reference source

not found. Error! Reference source not found..

Connecting to SYNC – Manual

5.2

If SYNC does not automatically detect the device, follow these instructions to manually connect it.

Step 1: Click on the

Step 2: Proceed through the Add Device Wizard and click End Device / Probe.

Set the communication parameters for the Omega Link Smart Interface that you are connecting to.

Figure 2: USB Communication Interface

• Connection Type: Select the type of connection you have between your SP-014 and your computer.

• Command Timeout: The maximum time (in milliseconds) for a command to be completed before the command is

Note:

The default command timeout is 500 milliseconds. It is recommended that this section be left alone to avoid

communication errors.

icon located on the top left of the SYNC interface.

Note:

The connection type and parameters must be accurate for a proper connection to be

established. Failure to accurately setup communication parameters may result in

communication errors.

aborted.

Figure 3: USB Serial Communication Interface

9 |

M 5 7 5 2

Table of Contents