Thermo Scientific VersaCool User Manual page 96

Chapter 4
| Operation
4-2
| VersaCool
When loading is complete the Power touchscreen will appear.
Temp
Probe
22.2°C
Temperature
This icon indicates the bath is using the internal temperature sensor. The procedure to
switch to the remote,
This icon indicates the approximate reservoir fluid level.
• Touch to place the bath into the sleep mode, this causes the screen to go blank. Touch
any part of the blank screen to come out of the sleep mode.
The display also shows the process fluid temperature as well as the set point. The set point is the
desired process fluid temperature.
• Touch to start the bath. The
Additional icons can be displayed but they are on only when that component is running/enabled.
This icon indicates the pump is running, it is always on when the bath is running.
This icon indicates the heater is on, it flashes when the heater is cycling on and off.
This icon indicates the refrigeration is on.
This icon indicates the timer, used to start/stop the bath at a specific time, is enabled.
This icon indicates a connectivity option is enabled.
Fluid Level
20.0°C
Set Point
, or outlet sensor, , is addressed later in this chapter.
icon becomes , touch it to stop the bath.
Thermo Scientific