Nibp Interval Button Shortcut - GE Corometrics 250cx Series Operator's Manual

NIBP Interval Button Shortcut

8-12
Maternal Non-Invasive Blood Pressure Monitoring: NIBP Monitoring
Example 2. The interval time is set at 15 minutes and the countdown timer
shows 2 minutes until the next reading — in other words 13 minutes have
elapsed. If you change the interval time to 10 minutes, the countdown timer will
wait another 10 minutes until the next reading. Therefore a total of 23 minutes
will elapse between readings.
You can set the interval time from the NIBP Setup screen or from the normal
operating screen using a front panel button shortcut:
1. While the normal operating screen is displayed, press and hold the
Stop
button on the front panel.
2. After holding for approximately 2 seconds, the interval field display in place of
the countdown timer. Refer to "NIBP Interval Time Shortcut," on page 8-12.
3. Continuous pressure on the
intervals: 1, 2, 3, 4, 5, 10, 15, 20, 30, 40, 45, 60, 90, and 120 minutes, and Off. Off
appears as a blank in the interval field display.
NOTES
Since the intervals are displayed in the countdown timer area, they appear
as follows: 1:00, 2:00, 3:00,... 60:00, etc.
The monitor is factory-set with the optional 1-minute interval time enabled.
For information on disabling the 1-minute interval, refer to the "250/250cx
Series Monitor Service Manual".
4. When the desired interval is displayed, release the
5. The timer reappears and begins to count down from the new value.
US
165 172
NIBP
130/ 85
MAP (107)
03:15
MECG
Print
250cx Series Maternal/Fetal Monitor
2036946-001
NIBP Start/Stop
NIBP Interval Time replaces the
countdown timer, while NIBP Start/Stop
button is held.
US2
FMD
MECG
15:00
87
Freeze Alarms
NIBP Start/
button cycles through the available
NIBP Start/Stop
button.
TOCO
HBC
30
MSpO2
98%
25 mm/s
II 2x
03:22:45
Setup VSHX
NIBP Interval Time Shortcut
Revision C