Primary Labor Parameters
FHR Display
3-8
Controls, Indicators, and Connectors: Primary Labor Parameters
The primary labor parameters section displays FHR1, FHR2, and UA data.
The FHR1 and FHR 2 areas are summarized in the following figure and table.
B
A
FHR Value
A
FHR Alarm Setting
Indicator
B
FHR Mode Title
C
D
FHR Heartbeat Indicator
250cx Series Maternal/Fetal Monitor
2036946-001
C
FHR Display
Name
Up to three digits indicate the fetal heart rate in
beats per minute.
This symbol provides information about the FHR
audio alarm and the FHR high/low alarm limit
settings. See Chapter 10, "Alarms" for more
information.
: All alarm settings are enabled.
At least one fetal alarm is disabled.
An abbreviation indicates the monitoring mode in
use: FECG, US, US2, or INOP. (FECG only
displays in the FHR1 area.) Select the mode
softkey to access the respective setup screen. See
"Connectors vs. Display Modes" Table below for
FHR connection options.
Flashes with each detected valid heartbeat.
D
FHR Display
Description
Revision C