Cleaning And Maintenance - BRAYER BR4225 Instruction Manual

• Before cleaning always make sure that the filters (19,
24) are installed properly.
• Take the power plug and unwind the power cord to the
required length, connect the power plug to the mains
socket.
• The yellow mark on the power cord indicates the
maximum cord length. Do not pull out the power cord
further than the red mark.
• Press the on/off button (15) to switch the vacuum
cleaner on.
• While cleaning you can control the suction power
using the manual suction power control (6) on the
flexible hose handle (5) and by turning the suction
power control (16).
• After you finish cleaning, switch the vacuum cleaner off
by pressing the on/off button (15) and unplug it.
• To wind the power cord, press the button (18); keep a
hold of the winding cord with your hand.
• If you have to make a break during the cleaning,
switch the vacuum cleaner off by pressing the button
(15) and install the brush (1) to the brush storage (19).
ATTENTION!
Before changing the attachments or cleaning the
dust bin (20), switch the vacuum cleaner off by
pressing the on/off button (15) and unplug it.

CLEANING AND MAINTENANCE

Cleaning the dustbag (15)
• If during cleaning the full dustbag indicator (14) turns
red, clean the dustbag (20) or replace the disposable
paper dustbag (27)
Note: the paper dustbag (27) is disposable, when the
dustbag (27) is full, dispose of it.
• Before cleaning the dustbag (20), switch the vacuum
cleaner off by pressing the on/off button (15) and unplug it.
• Open the dustbag compartment lid (13) by pressing the lid
lock (12).
• Remove the dustbag holder (21) with the dustbag (20)
(pic. 3).
• Take the dustbag (20) out from the holder (21).
• Place the dustbag (20) above the garbage bin, remove the
plastic clamp and clean the dustbag (20) of garbage and
dust. You can wash the dustbag (20) with warm water and
soft detergent, rinse and dry thoroughly. After that install
the plastic clamp on the dustbag (20).
• Install the dustbag (20) into the holder (21).
• Put the dustbag holder (21) with the dustbag (20) installed
into the dustbag compartment body.
• Close the dustbag compartment lid (13) and slightly press
on the lid (13) until the lock (12) clicks.
Notes:
– do not try to close the lid (13) without the dustbag holder
(21) installed, otherwise you can damage the lock or the lid
(13);
– before closing the lid (13), always make sure that the
dustbag holder (21) and the dustbag (20 or disposable paper
dustbag 27) are installed properly.
EN 9