Using The Vacuum Cleaner; Cleaning And Maintenance - BRAYER BR4226 Instruction Manual

USING THE VACUUM CLEANER

Attention! You can turn the vacuum cleaner on only with
the installed dustbag (15 or the disposable paper dustbag
(29), as well as with the inlet filter (16) and the outlet
HEPA filter (23) and the foam filter (24).
• Before cleaning always make sure that the filters (16,
23, 24) are installed properly.
• Take the power plug and unwind the power cord to the
required length, connect the power plug to the mains
socket.
• The yellow mark on the power cord indicates the
maximum cord length. Do not pull out the power cord
further than the red mark.
• Press the on/off button (17) to switch the vacuum
cleaner on (pic. 4).
• While cleaning, you can control the suction power
using the manual suction power control (6) on the
flexible hose handle (5) and with the suction power
control buttons (19) «-/+» (pic, 5) on the display (17)
will show the the optimum suction power ratio and the
surface type for cleaning (pic. 6).
- minimum power level
- optimal power for cleaning curtains, etc.
- high suction power and low noise level
- carpets cleaning
- maximum suction power, extremely dirty floors and
carpets cleaning
• After you finish cleaning, switch the vacuum cleaner off
by pressing the on/off button (17) and unplug it.
• To wind the power cord, press the button (20); keep a
hold of the winding cord with your hand (pic. 7).
• If you have to make a break during the cleaning, switch
the vacuum cleaner off by pressing the button (17) and
install the brush (1) to the brush storage (22).
ATTENTION!
Before changing the attachments or cleaning the dust
bin (15), switch the vacuum cleaner off by pressing the
on/off button (17) and unplug it.

CLEANING AND MAINTENANCE

Cleaning the dustbag (15)
• If during cleaning the full dustbag indicator (21) lights
up, empty the dustbag (15) or replace the disposable
paper dustbag (29).
Note: the paper dustbag (29) is disposable, when the
dustbag (29) is full, dispose of it.
• Before cleaning the dustbag (15), switch the vacuum
cleaner off by pressing the on/off button (17) and unplug
it.
• Open the dustbag compartment lid (13) by pressing the
lid lock (11) (pic. 8).
EN 9