Cleaning And Maintenance - BRAYER BR4206 Instruction Manual

10 EN
Note: provide that the filter (11) is always clean,
because the overall performance of the vacuum cleaner
depends on it.
Attention! Before switching on and using the vacuum
cleaner, make sure that the filter (11), the separator
(27), the dust bin (13) and the outlet filter (4) are
installed properly.
• Take the power plug (1) and unwind the power cord
to the required length, connect the power plug to the
mains socket (pic. 7).
• The yellow mark on the power cord indicates the
maximum cord length. Do not pull out the power cord
further than the red mark.
• Press the on/off button (8) to switch the vacuum
cleaner on (pic 8).
• While cleaning, you can control the suction power
using the manual suction power control (21) on the
flexible hose handle (19) (pic. 9).
• After you finish cleaning, switch the vacuum cleaner
off by pressing the on/off button (8) and unplug it.
• To wind the power cord, press the button (2); keep a
hold of the winding cord with your hand.
• If you have to make a break during the cleaning,
switch the vacuum cleaner off by pressing the button
(8) and install the brush (15) to the brush storage (7)
(pic. 10).
ATTENTION! Before changing the attachments
or cleaning the dust bin (13), switch the vacuum
cleaner off by pressing the on/off button (8) and
unplug it.

CLEANING AND MAINTENANCE

Cleaning the dust bin (13)
• It is recommended to remove garbage and dust from
the dust bin (13) after every room cleaning.
• Switch the vacuum cleaner off by pressing the on/off
button (8) and unplug it.
• Holding the handle (13), press the lock (9) and
remove the dust bin (13) (pic.11).
• Place the dust bin (13) over a garbage bin.
• Pull the lock (12) and open the lower lid (25) (pic.
12).
• Remove accumulated dust and garbage from dust
bin (13).
• Close the lid (25).
• Install the dust bin (13) back to its place and make
sure that the dust bin (13) is fixed properly.
Cleaning the filter (11) and the separator (27)
installed in the dust bin (1)
• Clean the filter block (11) at least once a month.
• Preliminarily remove dust and garbage from the dust
bin (13) as described above.
• Pull the upper lid clamp (10) and open the lid
(pic.13).