Cleaning And Care - BRAYER BR4265 Instruction Manual

10 EN
SWITCHING THE VACUUM CLEANER ON
Attention! Only turn on the Vacuum Cleaner with the
installed Dust Box (6) with the Mesh Filter (22) and
HEPA Filter (21) installed into it.
• During cleaning or when carrying the vacuum cleaner
hold the unit by the handle (3).
• For easy storing of the vacuum cleaner or the battery
charging use the wall-mounted holder of the vacuum
cleaner (25).
• Press the Power Button (2) to turn on the Vacuum
Cleaner - the Vacuum Cleaner will turn on in the Low
Suction Power Mode; press the Power Button (2)
again to turn the Vacuum Cleaner off.
• When using the Vacuum Cleaner, you can alternate
between Suction Power Modes by pressing the
Suction Power Setting Button (13); the Indication/
Operation Mode Selection Panel (1) will display the
Suction Power Mode (12).
• The Digital Indication (11) will display the Charge Level
of the Rechargeable Battery (4).

CLEANING AND CARE

Attention!
Keep the Dust Box (6), Mesh Filter (22), and HEPA
Filter (21) clean, the performance of the Vacuum
Cleaner depends on it.
• For best results, clean the Dust Box (6) after each use
of the Vacuum Cleaner; perform a periodic cleaning of
the Mesh Filter (22) and the HEPA Filter (21).
• Press and hold down the Lock (19) to remove the Dust
Box (6) (Fig. 8).
• To remove dust and garbage, position the Dust Box (6)
over the garbage bin, lift up the Lock (18) (Fig. 9) and
open the Cover (17) (Fig. 10), remove the dust and
garbage, close the Cover (17) so that the Lock (18)
activates.
• Reinstall the Dust Box (6), make sure that the Dust Box
(6) has been safely secured by the Lock (19).
Cleaning the Dust Box
• Press and hold down the Lock (19) to remove the Dust
Box (6) (Fig. 9).
• Remove any dust and garbage from the Dust Box (6),
as indicated above, before cleaning.
• Remove the Holder (20) from the Dust Box (6), detach
the Mesh Filter (22) and the HEPA-Filter (21), remove
the Mesh Filter (22) form the HEPA Filter (21).
• Wash the Mesh Filter (22) and HEPA Filter (21) under a
warm jet of running water and let them dry.
• Wash the dust bin flask (6) and dry.
• Do not wash all removable parts in a dishwashing
machine.
Note: before assembling the dust bin (6) make sure that
all removable parts are clean and dry.
Assembling of the dust bin
• Install the Mesh Filter (22) onto the HEPA Filter (21),