Cleaning And Care - BRAYER BR4266 Instruction Manual

SWITCHING THE VACUUM CLEANER ON
Attention! Only turn on the Vacuum Cleaner with the
installed Dust Box (7), and the Mesh Filter (18), HEPA-
Filter (19) and Outlet Filter (20) installed into it.
• During cleaning or when carrying the vacuum cleaner
hold the unit by the handle (1).
• For easy storing of the vacuum cleaner or the battery
charging use the wall-mounted holder of the vacuum
cleaner (23).
• Press the Power Button (6) to turn on the Vacuum
Cleaner - the Vacuum Cleaner will turn on in the Low
Suction Power Mode; press the Power Button (6)
again to turn the Vacuum Cleaner off (Fig. 11).
• When using the Vacuum Cleaner, you can alternate
between Suction Power Modes by pressing the
Suction Power Setting Button (15).
• The Indicators (16) display the residual charge level
of the Rechargeable Battery (3); an Indicator (16)
flashing during operation means that the Battery (3)
needs to be charged.

CLEANING AND CARE

Attention!
Keep the Dust Box (7), the Mesh Filter (18), the Hepa
Filter (19), and the Outlet Filter (20) clean for best
performance.
• For best results, clean the Dust Box (7) after each use
of the Vacuum Cleaner; perform a periodic cleaning
of the Mesh Filter (18), the HEPA Filter (19), and the
Outlet Filter (20).
• To remove dust and garbage, position the Dust Box
(7) over a garbage bin, press the Lock Button (8)
and open the Cover (Fig. 12), remove the dust and
garbage, close the Cover so that it would trigger the
Lock (8).
Cleaning the Dust Box
• Remove any dust and garbage from the Dust Box (7),
as indicated above, before cleaning.
• To remove the Dust Box (7) press and hold down the
Motor Unit Lock Button (5) to remove the Dust Box (7)
(Fig. 13).
• Extract the Outlet Filter (20) (Fig. 14) and clean it of
any dust.
• Rotate the HEPA Filter Holder (17) counter-clockwise
and extract it (Fig. 15).
• Rotate the HEPA Filter (19) counter-clockwise and
remove it, remove the Mesh Filter (18).
• Wash the Mesh Filter (18) and HEPA Filter (19) under
a warm jet of running water and let them dry.
• Wash the dust bin flask (7) and dry.
• Do not wash all removable parts in a dishwashing
machine.
Note: before assembling the dust bin (7) make sure that
all removable parts are clean and dry.
EN 9