BRAYER BR4225 Instruction Manual page 7

es the power cord, as this can lead to its damage and
cause a short circuit.
s • For children safety reasons do not leave polyethylene
able bags used as a packaging unattended.
ere
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger of
or
suffocation!
• The unit is not intended for usage by children.
• Do not leave children unattended to prevent using the
unit as a toy.
• Do not allow children to touch the operating surface,
the unit body, the power cord or the power plug during
operation of the unit.
• Be especially careful if children or disabled persons are
near the operating unit.
er
• During the unit operation and breaks between operation
ner
cycles, place the unit out of reach of children.
• The unit is not intended for usage by physically or
r
mentally disabled persons (including children) or by
persons lacking experience or knowledge if they are not
under supervision of a person who is responsible for
their safety or if they are not instructed by this person
m
on the usage of the unit.
• From time to time check the power cord insulation.
• If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or similar
qualified personnel to avoid danger.
lug
• Do not repair the unit by yourself. Do not disassemble
ull
the unit by yourself; if any malfunction is detected, and
after the unit has been dropped, unplug it and apply to the
service center.
• To avoid damage, transport the unit in the original
package.
• Keep the unit in a dry cool place out of reach of children
and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL OR
LABORATORY PURPOSES.
BEFORE THE FIRST USE
After the unit's transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using it.
• Unpack the unit and remove all the packaging materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do not
plug it into the mains.
• Make sure that the given specifications of supply voltage
of the unit correspond to the specifications of your mains.
When using the unit in the mains with 60 Hz frequency, the
unit does not need any additional settings.
EN 7