XYZ Printing PartPro300 xT User Manual page 19

Using print bed gauge:
In case the auto calibration & leveling found not accuracy, the print-bed gauge can be another choice to veri-
fy the print-bed leveling status. The gauge should smoothly slide into the gap between the print-bed and print
bed platform. If not, adjust the setscrew until to suitable height.
B. Z Offset
When the print bed is calibrated, perform the vertical calibration of Z offset to ensure the print head can eject onto the print
bed smoothly.
①
Press Z Offset icon.
②
Press + / - to adjust the print bed vertical height, after press "APPLY" to confirm the Z offset value.
Users can use a business card inserted to the space between the print head and the print bed to check whether it can pass
freely through it. If not, adjust the setscrew under the print bed.
C. Jog Mode
The jog mode is a function that allows you to manually control the position of the print head and the printing bed.
Press different arrow key to move the print head.
Return to the home point. Always return to the home point prior to any movement in any direction.
Move in the X axle direct.
Move in the Y axle direction.
Move in the Z axle direction
PartPro300 xT
18