Network Configuration - En-Vision America ScripTalk ST400 User Manual

Network Configuration
To set the printer's network configuration settings, follow the steps below.
1. Turn the printer on.
2. Tap the blue "OFFLINE" button.
3. Tap the "SETTINGS" button.
4. Use the 'level1' password to enter the System menu.
5. Tap the orange "Interface" button.
6. Tap through the following series of options: Network > Settings > LAN.
7. Tap "IPv4" or "IPv6".
8. Configure the printer's Mode for "Static".*
9. Configure the printer's IP Address, Netmask, Gateway, and DNS.*
*
Use the checkmark button to save, and the "X" to cancel.
The settings should take effect after several seconds. The printer should not need to be restarted.
13