Reloading The Profile - En-Vision America ScripTalk ST400 User Manual

Reset Types
• Data – Fonts and graphics.
Do not include Data in your reset unless instructed to do so by ScripTalk technical support.
• Settings:
o User – Resets the Settings values.
User (-Interface)
*
o Factory – Resets to factory default settings.
* Factory (-Interface)
Interface – Resets only those options found in the Settings > Interface area of the printer.
o
o Printing – Resets only options found in the Settings > Printing area of the printer.
After performing any reset, restart the printer to complete it (but do NOT pull the power cable from the printer).
Reloading the Profile
After User and Factory resets, reload the VA profile by following these steps:
1. Go to Settings > Tools > Profiles.
2. Tap "Load".
3. Tap "Envision_Government".
4. Tap the checkmark.
5. Tap the back arrow.
6. Tap "Start with".
7. Tap "Envision_Government".
8. Tap the checkmark.
To place the printer Online for printing, push the Home/Power button twice.
You can fully reflash the firmware using a set of restore files, available upon request by emailing
– Performs a User Reset without resetting Interface settings.
– Performs a Factory Reset without resetting Interface Settings.
In particular, this will set Network > Settings > LAN > IPv4|IPv6 > Mode to "DHCP".
support-sa@envisionamerica.com.
15