Huawei UPS2000-G Series User Manual page 84

UPS2000-G-(6 kVA-20 kVA)
User Manual
●
●
Issue 21 (2022-10-13)
Item Description
Power Determine whether to enable the
segment power segment function for a singe
UPS. (This function is not supported in
a parallel system). This parameter is
configurable only after the inverter
is shut down.
Self-Load screen
Figure 4-33 Self-Load screen
Table 4-23 Self-load settings
Item Description
Output This parameter is used only during
power the tests before shipment. This
ratio parameter is configurable only after
the inverter is shut down.
Self-load This parameter is used only during
mode the tests before shipment. This
parameter is configurable only after
the inverter is shut down.
Others screen
Figure 4-34 Others screen
NO TE
The EPO enable setting is available only for the UPS2000-G-15KRTL-01/UPS2000-
G-20KRTL-01. EPO is enabled for the UPS2000-G-6KRTS/UPS2000-G-10KRTS/
UPS2000-G-15KRTL/UPS2000-G-20KRTL by default.
Copyright © Huawei Technologies Co., Ltd.
4 Control Panel
Default Value
Value Range
Disabled Disabled
,
Enabled
Default Value
Value Range
80% 20%–
100%
Disabled Disabled,
Enabled
76