Shipping And Storing The System; Preparing The Electrical Circuits - Sun Microsystems Enterprise 3500 System Installation Manual

Tools
No. 2 Phillips screwdriver
System key for front door and key switch (packed in a bag in the accessory box)
Follow the graphical instructions on the shipping container to remove the system
from the container. Remove the system key (for front door and key switch), and
power cord from the shipping container. These are needed to power on the system.
Note – Any unpacking instructions printed on the outside of the shipping carton
take precedence over information in this section.
1.1.1

Shipping and Storing the System

Save the original shipping containers and packing materials in case you need to
store or ship your system.
If you cannot store the shipping materials, recycle or dispose of these materials
properly. Consult your local recycling authority for information.
1.2

Preparing the Electrical Circuits

In planning where to place your equipment, remember that each of the following
items requires access (by way of a separate power cord) to a power outlet:
Enterprise 3500 system
External peripherals
Monitor used for diagnostics
The Enterprise 3500 system uses nominal input voltages of 100-120 VAC or 200-220
VAC. Sun products are designed to work with single-phase power systems that have
a grounded neutral conductor.
To reduce the risk of electrical shock, do not connect Sun products into another type
of power source. Contact your facilities manager or a qualified electrician if you are
unsure what type of power is supplied to your building.
Chapter 1 Preparing for Installation 1-3