Table of Contents
Advertisement
Installing
Installing rack rails
The rack rails are marked for easy identification. The left rail is marked "L" and the right rail is marked "R".
Procedure
1. Install the right rail:
a. Align the front of the rail with the front of the rack column and the back of the rail with the rear rack column (1).
b. Slide the rear end of the rail into the rear rack column (2).
c. Slide the front end of the rail into the front rack column (3).
3
When fully seated, the rack rail locks into place.
2. Repeat step 1 for the left rail.
Installing the 1U support shelf
The 1U support shelf is required when no other enclosure will be installed directly underneath the D6020. Position the 1U
support shelf beneath where the D6020 disk enclosure will be installed in the rack.
Procedure
1. On each side of the rack (front and rear), install two clip nuts or cage nuts at the top and bottom of a 1U space.
2. Install each rear side bracket using two screws. Do not fully tighten the screws. L (left) and R (right) markings indicate
the correct side for installation when viewed from the front of the rack. The support pin should face inward and be at
the bottom of the U space.
8
Installing
1
2
Advertisement
Table of Contents
