1. Node
2. Upper D6020, Single Domain #1 Drawer #1, Single Domain #2 Drawer #2
3. Lower D6020, Single Domain #1 Drawer #1, Single Domain #2 Drawer #2
Figure 17: Connecting two D6020s in a single-domain environment to one node using two dual-port controllers
(Array mode)
Selecting and connecting the power cord
Approved power cords
The power cord used with the D6020 should be approved for use in your country. The power cord must be rated for the
product and for the voltage and current marked on the electrical ratings label of the product. The voltage and current
rating for the cord should be greater than the voltage and current rating marked on the product. In addition, the diameter
of the wire must be a minimum of 1.00 mm or 18 AWG. The maximum length may be up to 3.66 m (12 ft).
28
Installing
1
2
3