Table of Contents
Advertisement
Figure 1: Aligning the back of the chassis with the rails
WARNING: The chassis is heavy. To reduce the risk of personal injury or damage to the equipment:
•
Be sure that the rack is adequately stabilized before installing the chassis.
•
Always use either a lift that can handle the load of the product or get at least four people to lift and stabilize
the product during assembly, installation, or removal, especially if the chassis is not installed in the rack. An
additional person may be required to help align the chassis if the chassis is installed higher than chest level.
•
Observe local occupational health and safety requirements and guidelines for manual material handling.
•
Hewlett Packard Enterprise recommends that you note the location of each hard drive in each drawer, and
then remove all hard drives from the hard drive drawers before moving the D6020.
CAUTION: Be sure to keep the product parallel to the floor when installing the chassis. Tilting the product up or
down could result in damage to the rails.
3. Set the chassis securely on the left and right rack rails and slide the chassis onto the rack rails toward the rack rear (2).
4. Release the handles (1), as appropriate, just before they make contact with the rack columns. Be sure to slide the
chassis into the rack until it is fully seated inside the rack and on both rack rails.
5. Tighten the thumbscrews (3) on each side of the front of the chassis.
12
Installing
Advertisement
Table of Contents
