Installing mini-SAS I/O cables
The D6020 does not ship with any I/O cables but supports the use of 2.00 m (6.56 ft) mini-SAS cables. For information
about supported cables, see the QuickSpecs on the HPE website:
https://h20195.www2.hpe.com/v2/getdocument.aspx?docname=c05054941
Procedure
1. Connect a mini-SAS cable to port 1 on the primary (top) I/O module on the designated storage drawer.
2. Connect the other end of the mini-SAS cable to a port on the switch or node HBA.
3. If optional, additional I/O modules were installed, install an additional cable to port 1 of the secondary (bottom) I/O
module and to the redundant switch or node HBA port.
4. To connect the other D6020 disk drive drawer, repeat steps 1-3.
NOTE: The cable port LEDs should be linked at 12 gb/s and illuminated green after the cables are inserted. The cable
port LEDs should illuminate amber when linked at a lower speed.
Cabling the system
Cable the chassis as appropriate to your system configuration.
NOTE: The following figures are examples of supported cable diagrams. If your unit is part of a solution, refer to the cable
diagrams that shipped with your kit.
20
Installing