KM 37, 47, 57 and SL 17K Brackets Kit
PART NUMBER
530-040
530-043
530-556
540-130
540-132
Mount Bracket Installation
2) To install the mount brackets P/N 540-130 & 540-132, the handle must be removed as described in the
Operations and Maintenance manual Accessories module. Remove the two bracket mount screws and
washers from the top weight. These will be reused to mount the brackets.
3) Position the two brackets on the helmet and reinstall the two bracket mount screws and washers that go
into the top weight. DO NOT TIGHTEN.
© MMXVIII Kirby Morgan Dive Systems, Inc. All Rights Reserved
Kirby Morgan Dive Systems, Inc.
1430 Jason Way Santa Maria, California 93455
Phone: 805/928-7772
www.KirbyMorgan.com email: kmdsi@KirbyMorgan.com
Part #525-717
DESCRIPTION
Screw
Screw
Washer
Mount Bracket—Port Side
Mount Bracket—Starboard Side
1) Remove the two port retainer screws, one on either
side of the handle. These will not be reused to mount
the brackets.
4) Align the holes in the front part of the brackets
with the holes in the port retainer. Install one screw
in each bracket in the outer mount holes. (Screw P/N
530-040 supplied in the kit) DO NOT TIGHTEN.
Fax: 805/928-0342
QTY
2
3
1
1
1
Document #180905001
Page 1 of 2
®