Kirby Morgan 525-100 Quick Start Manual page 3

8) Slide the corrugated tube over the bent tube. The PVC flange previously installed in the reg shroud mates
with the corrugated tube, with the tube rubber going over the PVC Flange and the reg shroud rubber.
10) Attach the side block end of the bent tube to the side block assembly. Using the torque wrench and 11/ 1 6
attachment, torque the bent tube. See the "Torque Specs" module. If the regulator end of the bent tube was
loosened, torque the jam nut. See "Torque Specs" module.
© MMXXII Kirby Morgan Dive Systems, Inc. All Rights Reserved
Kirby Morgan Dive Systems, Inc.
1430 Jason Way Santa Maria, California 93455
Phone: 805/928-7772
www.KirbyMorgan.com email: kmdsi@KirbyMorgan.com
6) Install the rubber side block cover. Start by inserting
the one way valve through the square hole on the back
side of the cover. All the other holes will then line up
correctly.
7) Slide one of the PVC Flanges over the bent tube and
insert it into the regulator shroud.
9) Install the second PVC flange in the other end of the
corrugated tube. (1/4 of the flange should still show).
Fax: 805/928-0342
Document # 221222001 Page 3 of 4
®