Kirby Morgan 525-100 Quick Start Manual page 2

Kirby Morgan Dive Systems, Inc.
1430 Jason Way Santa Maria, California 93455
Phone: 805/928-7772
www.KirbyMorgan.com email: kmdsi@KirbyMorgan.com
3) Remove the emergency valve knob, nut, and spring.
4) Screw the regulator adjustment knob in all the way.
© MMXXII Kirby Morgan Dive Systems, Inc. All Rights Reserved
Fax: 805/928-0342
1) Disconnect the bent tube assembly at the side block
end only. Loosen the jam nut at the regulator. If the bent
tube will not swivel freely, you must loosen the large nut
at the regulator.
2) Remove the steady flow knob, locknut, and spring.
5) To install the rubber regulator cover, slide it over the
bent tube assembly and stretch it over the regulator ad-
justment knob.
®
Document # 221222001 Page 2 of 4