Table of Contents
Advertisement
For manual temperature specification (no temperature
Y
B
probe connected), the temperature is set using
During buffer selection, you can select the buffer set using
and
.
Y
B
Pressing cal + on/off when the meter is switched off,
+
cal
on/off
activates buffer selection.
When pressing two keys at the same time, make sure that
Note
the key shown at the left is pressed first.
Sensoface
Electrode Monitoring
The Sensoface
provides information on the electrode state. Zero point,
slope, response time, impedance and drying out are evalu-
ated.
For more detailed information on the displayed electrode
state and the individual evaluations of the parameters,
please see chapter "Troubleshooting and Maintenance"
(Pg. 17).
Connection and Start-up
Commercially available electrodes with a nominal elec-
Electrode
trode zero point of pH 7 and the following plugs can be
connection
connected:
– Coaxial standard plug to DIN 19 262
and/or
– 4 mm banana plug.
Y
and
automatic electrode monitoring system
Operation 5
B
.
Advertisement
Table of Contents
