3
|
Specific installer safety instructions
3 Specific installer safety instructions
Installer and user reference guide
12
Always observe the following safety instructions and regulations.
General
WARNING
Make sure installation, servicing, maintenance, repair and applied materials follow
the instructions from Daikin (including all documents listed in "Documentation set")
and, in addition, comply with applicable legislation and are performed by qualified
persons only. In Europe and areas where IEC standards apply, EN/IEC 60335-2-40 is
the applicable standard.
Unit installation (see
"16 Unit
For additional installation site requirements, read also
equipment using R32
refrigerant" [
WARNING
The appliance shall be stored in a room without continuously operating ignition
sources (example: open flames, an operating gas appliance or an operating electric
heater).
CAUTION
Appliance NOT accessible to the general public, install it in a secured area, protected
from easy access.
This unit, both indoor and outdoor, is suitable for installation in a commercial and
light industrial environment.
WARNING
Keep any required ventilation openings clear of obstructions.
CAUTION
This equipment is NOT intended for use in residential locations and will NOT
guarantee to provide adequate protection to radio reception in such locations.
CAUTION
Do NOT remove the (milky white) tape from the exterior of the indoor unit.
Removing the tape may cause an electric shock or a fire.
Refrigerant piping installation (see
CAUTION
Piping MUST be installed according to instructions given in
4
installation" [
compliant with the latest version of ISO14903 can be used.
4
installation" [
50])
4
14].
"17 Piping
60]. Only mechanical joints (e.g. braze+flare connections) that are
"3.1 Instructions for
4
installation" [
60])
VRV system air conditioner
4P673749-1A – 2022.11
"17 Piping
FXHA-A