Yamaha R15 2022 Service Manual page 91

1. Starter relay
2. Rear brake light switch lead
3. Positive battery lead
4. Fuse box
5. Lean angle sensor lead
6. Taillight assembly lead
7. OBD lead
8. Rear right turn signal light lead
9. License plate light assembly lead
10. Rear left turn signal light lead
11. S-CCU (Simple communication control unit)
12. Lean angle sensor
13. ECU (Engine control unit)
14. Negative battery lead
15. Battery box
16. Starter relay lead
17. Rear speed sensor lead
18. Fender
19. Wire harness
20. Fuse box lead
21. ECU band
22. Connector cover
CABLE ROUTING
A. Lead wires shall be clamped by hook of right side
fender. (In any random order)
B. Wire harness assembly shall be clamped to right
side of fender at the claw.
C. Hook of fuse box shall be inserted into right side
fender.
D. Band of ECU shall be inserted to right side fender.
E. After connecting OBD lead and S-CCU (Simple
communication control unit), OBD lead shall put in
under S-CCU.
F. Lead and connector of taillight assembly (3 pin
connector), license light assembly (2 pin
connector) and rear turn signal light assembly (left
& right) shall be covered by connector cover.
2-34
SPEC