EAS20025
ELECTRICAL SYSTEM
EAS30816
CHECKING AND CHARGING THE BATTERY
Refer to "CHECKING AND CHARGING THE
BATTERY" on page 8-143.
EAS30121
CHECKING THE FUSES
Refer to "CHECKING THE FUSES" on page
8-142.
REPLACING TURN SIGNAL INDICATOR
LIGHT BULB
1. Remove:
• Screw "1" from indicator light
• Lens "2"
2. Push the bulb "3" and remove by rotating
counterclockwise.
3
2
Turn signal indicator light screw
0.9 N·m (0.09 kgf·m, 0.6 lb·ft)
REPLACING LICENSE PLATE LIGHT BULB
1. Remove:
a. Screw "1" from license plate light.
b. License plate light bulb socket "2" (togeth-
er with the bulb) by pulling it out.
ELECTRICAL SYSTEM
1
3-28
c. License plate light burnt-out bulb "3" by
pulling it out.
2. Insert a new bulb into the socket.
3. Install the socket (together with the bulb) by
pushing it in.
4. Place the license plate light unit in the original
position, and then install the screw.
5. Tighten:
• License plate light screw
License plate light screw
0.5 N·m (0.05 kgf·m, 0.66 lb·ft)
EAS30664
ADJUSTING THE HEADLIGHT BEAMS
1. Adjust:
• Headlight beam (vertically)
Adjust the headlight beam by rotating the head-
light beam adjusting screw "1" with the help of
Phillip screwdriver "2" in direction "a" or "b" from
bottom side of headlight.
CHK
ADJ