EAS20230
BEARINGS AND OIL SEALS
Install bearings "1" and oil seals "2" so that the
manufacturer's marks or numbers are visible.
When installing oil seals, lubricate the oil seal
lips with a light coat of lithium-soap-based
grease. Oil bearings liberally when installing, if
appropriate.
ECA13300
Do not spin the bearing with compressed
air because this will damage the bearing
surfaces
EAS20240
CIRCLIPS
Before reassembly, check all circlips carefully
and replace damaged or distorted circlips. Al-
ways replace piston pin clips after one use.
When installing a circlip "1", make sure the
sharp-edged corner "2" is positioned opposite
the thrust "3" that the circlip receives.
3
IMPORTANT INFORMATION
1
2
1
2
EAS1MC1085
RUBBER PARTS
Check rubber parts for deterioration during in-
spection. Some of the rubber parts are sensitive
to gasoline, flammable oil, grease, etc. Do not al-
low any items other than the specified one to
contact the parts.
1-35
GEN
INFO