NEC e616 User Manual page 140

To
3 Put e616 in standby mode for
Bluetooth
4 Prepare e616 for a Bluetooth
connection
5 Dialup and connect
6 Disconnect
Do this
Select All devices.
Place e616 within the communication range of the Bluetooth
device.
Note: Depending on the radio communication condition, you
may have to place the device nearer to e616.
Note: The maximum distance for Bluetooth connection is 10
metres.
Note: When there is a wall or an electric device in between
the Bluetooth device and e616, the connection may be
interrupted.
Note: When a registered device is detected and the
authentication succeeds, a message is displayed.
Make sure that e616 is in the standby mode for connection.
From the PC application, start the dialup, and a connection is
established.
Note:When there is no action from the PC application, the
Standby timer expires and this operation will be cancelled
Disconnect from the PC application, select the PC name on
Bluetooth and press the Enter key, or press the SK2 (End all)
key (ends all Bluetooth connection and the standby status).
-123-
Connections