Stadler Form Eva Operating Instructions Manual page 9

output level automatically in order to reach and maintain the desired
humidity of 45 % quietly and in an energy-efficient way. The lower the
current humidity is, the higher the humidification output level will auto-
matically be set (under 33 % = level 4, from 34 % – 37 % = level 3, from
38 % – 41 % = level 2, from 42 % – 45 % = level 1). You can change the
desired humidity in auto mode by pressing the "Hygrostat" button (11)
several times while auto mode is active (the LED on the "Auto" button
on the unit is on). The humidification output level (12) cannot be altered
manually in auto mode. As soon as the "Output" button (12) is pressed
to change the humidification output level, the auto mode is deactivated.
11. You can use Eva to disperse fragrances in the room. Be extremely spar-
ing with fragrances because an excessive dosage can result in the mal-
functioning of, and damage to, the appliance. In order to use fragrances,
briefly press and release the fragrance container (20) and pull it out of
the appliance. Let the fragrance drip directly onto the cotton pad in the
fragrance container (20). Add a maximum of 1 – 2 drops of fragrance
into the fragrance container! Push the container back again and press
and release it to lock it. Tip: in order to change the fragrance, remove
the cotton pad and clean the container with soap. Now you may insert
a new cotton pad (commercially available) and add drops of the desired
fragrance.
12. If the water level indicator (16) changes to red, the water must be re-
filled. Remove the water tank (6) and fill it with clean, cold tap water
up to the maximum mark. Replace the water tank and press the on/off
button (10). The appliance will resume operation after a few seconds.
The water tank can also be refilled during operation.
13. If you find the lamps too bright (in a bedroom, for example), you may
reduce the light intensity by pressing the night mode key (21):
• Normal mode (default mode)
• Dimmed mode (push once)
• Lights-out mode (push twice)
• By pushing the dimmer button once more, you can go back into nor-
mal mode.
If there is no water in the appliance, the red water level symbol (16)
lights up in all modes. The red light cannot be dimmed.
14. If two dots are shown (22) on the display (15), Eva cannot establish a
radio connection to the Remote Sensor
to a humidity sensor within the appliance. Press any button on the Re-
mote Sensor
(2) is within a 10 m radius of Eva. Walls, doors and floors between Eva
and the Remote Sensor
mote Sensor
3 – 5 m from Eva and on an elevated surface in the middle of the room
(see «Setup/operation» No. 3). The two dots on the display (22) could
also indicate that the batteries in the Remote Sensor
ing (see «Setup/operation» No. 2).
15. Press the button for night mode (21) for 5 seconds to connect Eva to the
"Smart Life – Smart Living" app from Tuya Inc. (available from the App
Store and via Google Play) on your smartphone. The flashing water level
indicator (16) shows that WiFi is switched on. You can control all the
functions of the appliance via the app and monitor the air quality in real
time, even when you are not at home. For more detailed information on
(2) to activate it. Make sure that the Remote Sensor
TM
(2) can disrupt the radio connection. The Re-
TM
(2) should be optimally positioned at a distance between
TM
(2). Eva still functions thanks
TM
TM
TM
(2) need replac-