Stadler Form Eva Operating Instructions Manual page 10

how to connect your Eva to your smartphone, see the enclosed "WiFi –
Quick Setup Guide"
Note: Should you see droplets (or other signs of dampness) on or around
the unit, this condensed water is from the humidifier. This means that the
air can no longer absorb the moisture from the humidifier. Please activate
the auto mode with a desired humidity of 45 %. Water droplets should then
stop forming.
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (1) from the socket.
Attention: Never submerge the appliance in water (danger of short-circuit).
If pre-heating is turned on (the warm mode LED is on (13)), the water inside
the appliance is heated: the water in the water tray (9) and the heating plate
(17) become hot. Avoid touching the water and the heating plate!
For hygienic reasons and to ensure proper operation, we recommend the
following cleaning intervals.
• Daily: Fill the water tank (6) with fresh, cold tap water. If the appliance
is not used for several days, empty the water from the water tray (9) be-
forehand and if necessary, clean it with a bit of dish detergent and a clean
cloth. Fill fresh water into the water tank (6), before putting the appliance
back into operation.
• Every 2 weeks: First remove the water tank (6), the mist chamber (23),
the cover (18) and the Water Cube™ (24). Clean the inside of the water
tray (9) thoroughly with a bit of dish detergent, warm water and a soft,
clean cloth, sponge or brush. Use diluted descaling agent (mix according
to the manufacturer's instructions) for lime deposits. Then rinse the water
tray (9) thoroughly with cold water and put the water tank, cover (18), mist
chamber (23) the Water Cube back in.
• Run the cleaning mode at least once per month. The appliance must
be off for at least 15 minutes prior to internal cleaning! Then remove the
water tank (6), the mist chamber (23), the cover (18), the Water Cube (24)
and the fragrance container (20). Fill a cup with 200 ml of tap water mixed
with descaling agent (mix according to the manufacturer's instructions).
Pour the liquid carefully into the water tray (9) by holding the cup directly
over the water tray (see page 5). Do not pour the liquid into the water
tray from high above the tray! Be sure that no liquid enters the air outlet
opening (26). This will damage the appliance and will void any claim to
the warranty.
• To start the cleaning mode, the mains cable must be connected to a sock-
et. Press and hold the night mode button (21) on the underside of the right
corner for 5 seconds to activate the cleaning mode. Now the water level
symbol (16) on the appliance will blink red. The cleaning mode runs for
around 5 minutes and automatically turns off afterwards (the water level
symbol stops blinking).
• Check in the water tray (9) if the limescale on the ultrasonic membrane
(19) and the heating plate (17) has dissolved. Attention: the water and the
heating plate are hot, risk of scalding!
• If limescale residue remains, the ultrasonic membrane (19) and the heat-
ing plate (17) can be cleaned with the help of the cleaning brush (25)
(front- and backside). Do not try to scrape them with a hard object.