Table of Contents
Advertisement
The Start Center
The Start Center buttons have the following function:
• Transfer – You switch the HMI device to the "Transfer" operating mode.
The transfer mode is only activated if at least one data channel has been configured.
• Start – You start the project on the HMI device.
If you do not perform an operation, a project already loaded on the HMI device will start
automatically in line with the settings in the Control Panel . If no project is loaded, the Start
Center will activate the transfer.
• Settings – You start the Control Panel.
• Taskbar – You open the task list and the Start menu.
The Start Center is displayed again if a project on the HMI device has been closed or if it is
accessed from the project.
3.4.2
Entering the IP address and name server
You can change the network settings for the LAN connection under "Network&Dial-
Up Connections". You can also configure the properties of the Ethernet ports of the HMI
device.
Requirement
The Control Panel is open.
Procedure
Proceed as follows:
1. Open the network adapter display using the "Network&Dial-Up Connections" icon.
The image below shows the network adapter of a KP1500 Comfort.
The second network adapter "PN_X3" is present for the Comfort devices as of 15".
2. Open the "PN_X1" entry.
The 'PN_X1' Settings dialog opens.
3. Change to the "IP Address" tab.
4. Select the type of address assignment:
– To determine the address manually, select "Specify an IP address".
Analyzer Intelligence Director
Operating Instructions, 05/2022, A5E51328515-AA
3.4 Changing the SIMATIC HMI network settings
Commissioning
17
Advertisement
Table of Contents
