Connecting The Radio In Blank Flash Mode; Figure 7: Connecting The Radio In Blank Flash Mode (1 Of 2) - Motorola ST7000 Basic Service Manual

4.2.1

Connecting the Radio in Blank Flash Mode

The function of this mode is for blank board flashing.
Procedure:
1 Flip up the battery eliminator switch.
2 Connect the serial data cable to the PC.
3 To enter Boot Me mode, press the On/OFF button or connect the programming cable to the PC.

Figure 7: Connecting the Radio in Blank Flash Mode (1 of 2)

1
No.
1
2
3
4
4 Push the battery eliminator switch to the middle.
5 Ensure that the programming cable is connected to the radio and the PC.
6 Flash the software or firmware to the radio.
3
Description
Personal Computer
Power Supply 3.8 V
Serial Data Cable
Programming Cable (USB Type-C)
MN002952A01-AH
Chapter 4: Test Setup and Testing
2
GND +ve GND
4
+ve
39