Leading The Cables Into The Interface Cabinet; Connecting The Cables In The Interface Cabinet; Connecting The Cables To The Connecting Terminal Plate - SMA SUNNY CENTRAL 500CP XT Installation Manual

SMA Solar Technology AG

12.2 Leading the Cables into the Interface Cabinet

1. Remove the four screws at the top of the sealing plate.
2. Remove the sealing plate.
3. Release the three screws at the side of the sealing plate.
4. Remove the required cable support sleeves from the sealing plate. Make sure that the diameter of the cable support
sleeves corresponds to the diameter of the cables to be inserted. Use the additional cable support sleeves included
in the scope of delivery, if necessary.
5. Remove the sealing plugs from the cable support sleeves.
6. Insert the cables through the cable support sleeves.
7. Insert the cable support sleeves into the sealing plate without deforming them. This will guarantee a tight fit.
8. Tighten the screws at the side of the sealing plate.
9. Screw the sealing plate to the floor of the interface cabinet.

12.3 Connecting the Cables in the Interface Cabinet

12.3.1 Connecting the Cables to the Connecting Terminal Plate

1. Dismantle 60 mm of the cable.
2. Strip 5 mm off the conductor insulation.
3. Connect the cable in accordance with the circuit diagram.
Installation Manual
12 Cable Connection of External Devices and Connections in the Interface Cabinet
SCCPXT-IA-D7-en-42 55