Ublox JODY-W1 Series System Integration Manual page 50

Command parameters
Sleep_Mode
Value
0x00
0x01
Idle_Threshold_Host
Value
0x00-0xFF
Idle_Threshold_HostController
Value
0x00-0xFF
BT_DEV_WAKE_Active_Polarity
Value
0x00
0x01
BT_HOST_WAKE_Active_Polarity
Value
0x00
0x01
Allow_Host_Sleep_During_SCO
Value
0x00
0x01
Combine_Sleep_Mode_And_LPM
Value
0x00
0x01
Enable_Tristate_Control_Of_UAR
T_Tx_Line
Value
0x00
0x01
UBX-16012621 - R18
C1-Public
Sleep mode algorithm selection.
Parameter description
No sleep mode
UART with out-of-band signals
Number of firmware loops executed with no 'activity' before Host
Controller deasserts BT_HOST_WAKE line. 'Activity' includes HCI traffic
and the presence of SCO connection if Allow_Host_Sleep_During_SCO is
not set.
Parameter description
Number of firmware loops, each roughly equivalent to 12.5 ms
Number of firmware loops executed with no 'activity' before Host
Controller considers itself as in idle. 'Activity' includes HCI traffic and
the presence of ACL/SCO connections.
Parameter description
Number of firmware loops, each roughly equivalent to 12.5 ms
This flag indicates whether the BT_DEV_WAKE line is active low or high. Size: 1 Octet
Parameter description
Active low
Active high
This flag indicates whether the BT_HOST_WAKE line is active low or
high.
Parameter description
Active low
Active high
Parameter description
Host is not allowed to sleep while SCO/eSCO connection is active. Host Controller keeps
BT_HOST_WAKE line asserted during active SCO/eSCO
Otherwise
Parameter description
Host Controller is allowed to sleep during sniff/hold/park regardless of BT_DEV_WAKE
line state
Host Controller is allowed to sleep during sniff/hold/park if BT_DEV_WAKE line is
deasserted
Parameter description
Host Controller will not tristate its UART TX line during sleep
Otherwise
Software
JODY-W1 series - System integration manual
Size: 1 Octet
Size: 1 Octet
Size: 1 Octet
Size: 1 Octet
Size: 1 Octet
Size: 1 Octet
Size: 1 Octet
Page 50 of 72