GE MDS iNET Series Reference Manual page 72

192.168.0.10
Terminal
or Computer
Figure 2-48. Point-to-Multipoint IP-to-Serial Application Diagram
Transceiver Location
PC
Access Point (COM2)
Remote Units (COM2)
1. This address is an example only. Any Class D IP address
(224.0.0.0–239.255.255.255) will work.
2. Either COM port can be used, but they must be the same ones at
both ends of the link. Both COM ports can be used simultaneously for
two independent data channels.
3. Flow Control applies to the COM2 Port only.
60
192.168.0.1
EIA-232
Access Point
Table 2-2. Serial Port Application Configuration
Menu Item
IP Protocol
Remote IP Address
Local IP Port
2 N/A
2 Enable
Baud Rate
Serial Mode
Flow Control
IP Protocol
Remote IP Address
Remote IP Port
Local IP Port
Local Multicast
Address
MDS iNET Series Reference Manual
Invisible place holder
192.168.0.2
EIA-232
Remote
192.168.0.3
EIA-232
Remote
EIA-232
192.168.0.4
Remote
Setting
UDP
224.254.1.1—
Multicast Address
30011
None required
Enabled
2,400 (Example)
Custom
3 Hardware (Example)
UDP
192.168.0.1
30011
30011
224.254.1.1 —
Multicast Address
RTU
RTU
RTU
1
1
05-2806A01, Rev. L