GE MDS iNET Series Reference Manual page 35

• —Unit's IP address [
IP Address
• —Condition of the unit's association with an Access Point. During an alarmed state,
Device Status
the radio will display Alarmed and the current connection status.
At the Access Point:
• Alarmed—A alarm event has been logged and not cleared.
• Operational—Unit operating normally.
At a Remote:
• Scanning—The unit is looking for an Access Point beacon signal.
• Exp(ecting) Sync(hronization)—The unit has found a valid beacon signal for its network.
• Hop Sync—The unit has changed its frequency hopping pattern to match that of the Access
Point.
• Connected—The unit has established a radio (RF) connection with the Access Point, but has not
obtained cyber-security clearance to pass data.
• Associated —This unit has successfully synchronized and associated with an Access Point.
• Alarmed—The unit has detected one or more alarms that have not been cleared.
NOTE:
If an alarm is present when this screen is displayed, an "A)" appears to the left of the
field. Pressing the "A" key on your keyboard takes you directly to the "Current Alarms" screen.
• —Elapsed time since the transceiver was powered-up.
Uptime
•
Firmware Version
•
Hardware Version
• —Make a record of this number. It must be provided to purchase Authorization Keys
Serial Number
to upgrade unit capabilities. (See "Authorization Key Menu" on Page 89.)
•
Configuration Summary
that are currently enabled or being used. View Figure 2-10 below and Figure 2-11 on Page 24 for
details.
Figure 2-10. Configuration Summary Screen (iNET-II AP)
05-2806A01, Rev. L
192.168.1.1
—Version of firmware that is currently active in the unit.
— Hardware version of the transceiver's printed circuit board.
—High-level view of configured system parameters. This shows parameters
MDS iNET Series Reference Manual
]
Device Status
23