Daikin FXHQ63AVEB8 Installer And User Manual page 52

16 | Unit installation
To check for water leaks
Installer and user reference guide
52
b Rectangular part of the decoration side panel
c Decoration side panel
d Screw
e Reinforcing plate
f Right drain piping
Drain piping connection
1
a b
1
a Drain pipe connection (attached to the unit)
b Drain hose (accessory)
c Metal clamp (accessory)
d Large sealing pad (accessory)
e Drain piping (field supply)
f Tightened part of metal clamp
A In case of bending the end of the metal clamp
B In case of wrapping the end of the metal clamp with vinyl tape
1 Push the drain hose as far as possible over the drain pipe connection.
2 Tighten the metal clamp at the base of the drain socket. Wrap the end of the
metal clamp with vinyl tape or bend the end inwards to avoid damaging the
sealing pad.
3 Check for water leaks (see
4 Wind the large sealing pad (= insulation) around the metal clamp and drain
hose, and fix it with tie wraps. Start wrapping from the tightened part of the
metal clamp so that the end of the metal clamp is wrapped twice.
5 Connect the drain piping to the drain hose.
Make sure the unit is level in accordance with the instructions in
when installing the indoor
through the air discharge outlet, and check for leaks.
a
b
a Air outlet
b Plastic water container with tube length ≥100 mm
2~5
c d
2 3 4
A
A
A' A'
A-A'
A B
d c b f d c b
"To check for water
4
unit" [ 46]. Gradually pour approximately 1 l of water
(mm)
e
5
A-A'
f
4
leaks" [ 52]).
"16.2.1 Guidelines
VRV system air conditioner
4P715928-1 – 2022.11
FXHQ-A