Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for ADAPT SOLUTIONS XL-Seat XLS-DAKQ05R
Summary of Contents for ADAPT SOLUTIONS XL-Seat XLS-DAKQ05R
- Page 1 XL-SEAT INSTALLATION MANUAL XLS-DAKQ05R DODGE DAKOTA QUAD CAB 2005-2011 PASSENGER...
- Page 2 PLEASE NOTE THAT THE PICTURES IN THIS MANUAL WERE TAKEN DURING AN INSTALLATION ON THE DRIVER SIDE. HOWEVER, THE INSTALLATION PROCEDURE IS THE SAME ON THE PASSENGER SIDE. 1- Remove the seat belt from the upper part of the “B” pillar and remove the plastic shroud.
- Page 3 4- Remove the lumbar support wheel. NOTE: The lumbar support will no longer be adjustable. Unclip the wheel and cut the shaft flush with the seat. 5- Unbolt the two bolts that hold the rear of the driver’s seat. Install the floor adaptor # XLS-DKTAQ97R-01.
- Page 4 7- Install the XL-SEAT onto the floor adaptor. Secure the bottom of the XL-SEAT in place using a 3/8” x 3/4” bolt. (Picture 1) Attach the top of the XL-SEAT to the adaptor # XLS-DKTAQ05R-03 using two (2) 5/16” x 3/4” bolts. (Picture 2) Now tighten the 3/8” x 3/4”...
- Page 5 10- Final inspection: Make sure all bolts are all properly fastened. Make sure that XL-SEAT works well with and without a passenger. Make sure the door closes properly. (Note: It is normal for the XL-SEAT to touch the door panel trim.) ...
- Page 6 ELECTRICAL INSTALLATION FOR XL-SEAT 1. Thread the lead power cable (red +) under the doorstep moulding and thru the firewall. WARNING: Pass thru a grommet in the firewall to prevent the cable from chaffing. 2. Install the circuit breaker near the battery and then connect the battery to the circuit breaker.
- Page 7 ELECTRICAL BOX CONNECTIONS XL-SEAT ALONE CTRL BOX: EW-CBX-01 PENDANT: EW-CON-04 RED = 12V POWER SUPPLY BLACK = GROUNDED TO THE CHASSIS GREY WIRE TO THE PENDANT TWO YELLOW WIRES RED = 12V POWER SUPPLY BLACK = GROUNDED TO THE TO THE XL-SEAT ACTUATOR CHASSIS XL-SEAT 2005-2011 DODGE DAKOTA QUAD CAB PASSENGER...
-
Page 8: Warning Decals
WARNING DECALS After completing the installation of the XL-SEAT, please take the time to install the warning decals. NOTE: The surface must be clean, dry and an ambient temperature for the sticker to stick to the surface. Start by locating a position to install the decals. ... -
Page 9: Troubleshooting
Burnt out switch. Replace pendant. Bad connection. Check the electronic module under the seat. Make sure that all the wires are properly connected. Burnt out electronic module. Contact Adapt Solutions for replacement module. Burnt out actuator. Replace actuator. Power Loss. The XL-SEAT motor is not getting adequate electrical power because of a loose connection. - Page 10 The only remedy for a defect in one of Adapt Solutions products shall be the repair or the replacement, at the discretion of Adapt Solutions, of the defective part or component. If repair or replacement is not commercially practical or cannot be timely made, Adapt Solutions may decide to refund the purchase price of the equipment (XL-SEAT) instead of repairing or replacing the original equipment.
- Page 11 XL-SEAT 2005-2011 DODGE DAKOTA QUAD CAB PASSENGER p. 11...
Need help?
Do you have a question about the XL-Seat XLS-DAKQ05R and is the answer not in the manual?
Questions and answers