Table of Contents
Advertisement
CABIN SWITCH 1 & 2,
3 & 4
INPUT 1,2
REL 1, 2
LAN 1–3
WAN
DIV
MAIN
SIM 1,2
2.5 Overview of LED Indicators
®
The 2N
LiftGate status is signaled by LED indicators on the device front side. Refer to the table
below for the statuses.
DEVICE STATUS
Indicates the
general system
status.
Cabin switch connection (3 & 4 are only supported by the dual
supply version of the device).
User configurable inputs.
Relay with NO/NC contacts.
LAN connector, 10/100/1000BaseT, RJ-45; Ca5 or higher
(recommended), LAN1 provides PoE 802.3af Class 2 (6.45 W max).
WAN connector, 10/100/1000BaseT, RJ-45; Ca5 or higher
(recommended).
Optional LTE antenna with an SMA connector for a better signal
quality.
Main LTE antenna with an SMA connector.
SIM card slots. The use of SIM 2 is optional. PIN-secured SIM cards
can be inserted. Make sure that the PIN code is set in the
configuration to put the device in operation.
LED Indicators
•
Blue – device status OK, device operational
•
Blue, slow flashing – device error that does not affect the full
functionality of the device
•
Red – temporary error (to be solved automatically, e.g. provider
service failure)
•
Red, slow flashing – permanent error (admin intervention is
required, e.g. via the device web interface)
•
Red, fast flashing – HW error, on-site service intervention is
required (e.g. DSL short-circuit, battery error/defect)
2N® LiftGate User Manual
17 / 85
Advertisement
Table of Contents
