Table of Contents
Advertisement
•
DSL voltage – DSL module supply voltage (10.5 V).
•
Line 1 voltage / current – line 1 voltage and current (48 V, 1 A max, recommended: up to
0.7 A).
•
Line 2 voltage / current – line 2 voltage and current (48 V, 1 A max, recommended: up to
0.7 A).
3.1.3.1 External Battery Connection
2
Use a 1.5 mm
wire of the maximum length of 1 m for external battery connection. Thread the
cable through the mains cable bushing using the larger hole. Maintain polarity while connecting
the battery.
Caution
•
Make an incision in the silicone bushing as indicated to insert a cable.
•
If the external battery is not connected, use a plastic blind to close the mains cable
threading hole.
3.1.4 Input and Output Pins
The Input / Output Pins tab shows the states of the device logic inputs and outputs.
•
Input 1 – 0 means that the input is deactivated (voltage below 2 V), 1 means that the IN1
input is activated (voltage above 4 V).
•
Input 2 – 0 means that the input is deactivated (voltage below 2 V), 1 means that the IN2
input is activated (voltage above 4 V).
•
Output 1 – 0 means that the relay is open (connected pins 1 and 2), 1 means that REL1 is
closed (connected pins 2 and 3).
•
Output 2 – 0 means that the relay is open (connected pins 4 and 5), 1 means that REL2 is
closed (connected pins 5 and 6).
2N® LiftGate User Manual
33 / 85
Advertisement
Table of Contents
