Installing The Sma Connector - Siemens CIM Operating Manual

Mounting and connecting the device
4.3 Installing expansion modules
4.3.2

Installing the SMA connector

Requirement
• The device is disconnected from the power supply and the DIAG LED goes out.
Procedure
Follow the steps to install the SMA connector.
1. Press the marked recesses on both left and right sides of the module with a flat-blade
screwdriver to loosen and then remove the middle housing.
2. Remove the shelter on the middle housing.
34
Operating Manual, 11/2022, A5E51250518-AC
CIM