Protocol Settings; Overview For Multi-Protocol - Siemens CIM Operating Manual

Web-based configuration
5.4 Web pages
Add a online variable
1. Click 'Add Row' button.
2. Enter the parameters of the variable. You can add maximum 16 variables at most.
Range: UDM address type of variable
Type: data type of the variable
Address: address in the CIM
Value: variable value in the selected address
ModValue: the new value you want to enter in the selected address
Modify: Click the check mark to modify the value in the selected address
3. Repeat step 1-2 to add all variables you need.
Delete a variable
Click
Click "Modify All values" to save all the changes.
5.4.7

Protocol Settings

5.4.7.1

Overview for multi-protocol

This page allows you to configure the following protocols: S7, Modbus TCP, Modbus RTU,
RESTful API.
5.4.7.2 S7
This page allows you enable or disable the S7 connections, as well as check and edit the S7
connections.
CIM supports maximum four S7 connections simultaneously at most. CIM will share the
connections if it acts as S7 server and S7 client at the same time.
Note
When you setup S7 communication between a remote device to CIM, make sure S7
communication is enabled in the connected remote device.
62
delete button next to the variable you want delete.
Operating Manual, 11/2022, A5E51250518-AC
CIM