Table of Contents
Advertisement
3 .0
• The ram pressure is set from the factory (60kN), but can be adjusted up or down if required .
3.0
• Be sure that the proper length rivet has been used for the thickness stack . Refer to Section 4 .1
3.3 Pressure Adjustment
• If the self piercing rivet does not sit flush with the panel, pressure needs to be increased. To increase pressure,
turn the pressure adjustment knob clockwise . To decrease pressure, turn the pressure adjustment knob
• The ram pressure is set from the factory, but can be adjusted up or down if required.
• Be sure that the proper length rivet has been used for the thickness stack. Refer to Section 4.1
counter-clockwise .
• If the self piercing rivet does not sit ush with the panel, pressure needs to be increased. To increase
pressure, turn the pressure adjustment knob clockwise. To decrease pressure, turn the pressure adjustment
knob counter-clockwise.
Good
BEFORE USING THIS DEVICE
Decrease Pressure
Turn pressure adjustment
knob counter-clockwise
Full Counter
Clockwise
Increase Pressure
Turn pressure adjustment
knob clockwise
5-7 kn
8
1.5 turn
3 Turns
20 kn
50 kn
All Info Copyright © Pro Spot International Inc.
For Instructional Videos:
https://www.youtube.com/c/Prospotwelding
BEFORE USING THIS DEVICE
BEFORE USING THIS DEVICE
Bad
Increase Pressure
Turn pressure adjustment
knob clockwise
1.5 turn
3 Turns
20 kn
50 kn
All Info Copyright © Pro Spot International Inc.
All Info Copyright © Pro Spot International Inc.
Bad
Press Button
to Decrease
Pressure
Press Button
to Increase
Pressure
8
Advertisement
Table of Contents
