Table of Contents
Advertisement
5 .3
Rivet Removal Procedure:
1 . Make sure rivet gun ram is fully retracted . If it is not, press Manual Retraction Button .
(Shown in Section 2 item #9)
2. Screw in the Rivet Removal tool (Male) into the fixed side of the C-Arm. TIGHTEN THREADS FULLY
TO AVOID DAMAGE TO THREADS .
3 . Screw in the Rivet Removal tool (Female) into the MOVING side of the rivet gun . TIGHTEN THREADS
FULLY TO AVOID DAMAGE TO THREADS .
4 . Align the Male Removal Die to the indented material on the "Formed" side of the rivet joint . OR use a
center punch to create a dimple on the "Formed" side for the male removal die to be centered, allowing
the rivet to pass through the female die properly .
5. Squeeze trigger to extend FEMALE removal tool. Continue to hold trigger until tool fully extends
and retracts .
6 . Remove Rivet slug from FEMALE removal tool .
FORMED SIDE WITH FACTORY DIMPLE OR
IF MALE DIE IS CENTERED
ON FORMED SIDE, THE HEAD
OF THE RIVET WILL PASS
THROUGH THE FEMALE DIE
CORRECTLY.
For Instructional Videos:
https://www.youtube.com/c/Prospotwelding
PR-8 RIVET REMOVAL PROCESS
CORRECT
CENTER PUNCHED DIMPLE
PLACE MALE DIE INTO THE DIMPLE
MALE DIE
FEMALE DIE
For Instructional Videos:
www.YouTube.com/ProSpotInternational
All Info Copyright © Pro Spot International Inc.
14
5.4
5.4 Rivet Removal
Procedure:
1. Make sure rivet gun ram is fully retracted. If it is not, pr
Section 2 item #9)
2. Screw in the Rivet Removal tool (Male) into the xed s
TO AVOID DAMAGE TO THREADS.
3. Screw in the Rivet Removal tool (Female) into the MO
FULLY TO AVOID DAMAGE TO THREADS.
4. Align the Male Removal Die to the indented material o
center punch to create a dimple on the "Formed" side
the rivet to pass through the female die properly.
5. Squeeze trigger to extend FEMALE removal tool. Cont
and retracts.
6. Remove Rivet slug from FEMALE removal tool.
INCORRECT
FORMED SIDE WITHOUT DIMPLE
MALE DIE
FEMALE DIE
APPLICATION OF THE DIE
USE A CENTER PUNCH
TO CREATE A DIMPLE
IN THE CENTER OF THE
FORMED SIDE
IF MALE DIE IS NOT CENTERED
ON FORMED SIDE, THE HEAD OF
THE RIVET WILL IMPACT THE
FEMALE DIE AND WILL BREAK
THE MALE DIE.
IF MALE D
ON FORM
OF THE R
THROUG
CORREC
14
Advertisement
Table of Contents
