Table of Contents
Advertisement
5 .4
5.5
5.5 Sheet Flattening
Sheet Flattening Procedure:
1 . Make sure rivet gun ram is fully retracted . If it is not, press Manual Retraction Button .
Procedure:
(Shown in Section 2 item #9)
1. Make sure rivet gun ram is fully retracted. If it is not, press Manual Retraction Button. (Shown in
2 . Install Flattening Die on Piston Side . TIGHTEN THREADS FULLY TO OR DAMAGE TO DIE/PISTON
RAM THREADS WILL OCCUR!
Section 2 item #9)
2. Install Flattening Die on Piston Side. TIGHTEN THREADS FULLY TO OR DAMAGE TO DIE/PISTON
3. Install Flattening Die on Fixed Side. TIGHTEN THREADS FULLY TO OR DAMAGE TO DIE/PISTON
RAM THREADS WILL OCCUR!
RAM THREADS WILL OCCUR!
3. Install Flattening Die on Fixed Side. TIGHTEN THREADS FULLY TO OR DAMAGE TO DIE/PISTON
4. Bring gun arm assembly to the work piece joint to be flattened. Position in location. Squeeze rivet
RAM THREADS WILL OCCUR!
gun trigger to extend ram until rivet meets the sheet to flatten. Continue to hold trigger until
4. Bring gun arm assembly to the work piece joint to be attened. Position in location. Squeeze rivet
flattening process is completed and ram retracts.
gun trigger to extend ram until rivet meets the sheet to atten. Continue to hold trigger until
attening process is completed and ram retracts.
15
For Instructional Videos:
APPLICATION OF THE DIE SETS
APPLICATION OF THE DIE SETS
FLATTENING DIES INSTALLED
1
2
All Info Copyright © Pro Spot International Inc.
Gun Side
3
Arm Side
Advertisement
Table of Contents
