Rivet Removal - Pro Spot PR-8 Instruction Manual

5 .3
FIXED Side
Step 2
Step 3
Step 4
STEP ONE:
Install the PRR-10HD on the FIXED side of the arm. Do not use an Extension Die.
Install the PRR-11HD on the DRIVEN side of the gun .
STEP TWO:
Engage the alignment pocket of the PRR-10HD on the formed side of the rivet .
The counterbore should t snug around the formed side (inside of the vehicle typically) .
STEP THREE:
Pull the PR-8 gun trigger. The ram will extend, and the elastic plastic spring will compress.
ONCE THE RIVET IS REMOVED, LET GO OF THE TRIGGER .
STEP FOUR:
Press the manual retract button on the PR-8 to return the ram to the retracted position .
The elastic plastic spring will return to the uncompressed state and draw the PRR-10HD out of the
hole that the rivet was extracted from.
13
PR-8 RIVET REMOVAL PROCESS
PRR-10HD PRR-11HD
All Info Copyright © Pro Spot International Inc.
DRIVEN Side